Products

EDGE MIRRORS

Edge mirrors are designed for the use of Numismatists to inspect the edge surface of collectible valuable coins. Many old coins had printing stamped onto the edge to prevent the gold and silver from being scraped off and collected by dishonest persons. The same reason our government began using the reeding around the edges of USA coins. The coin to be inspected is placed inside the edge mirror. Then if looked at or photographed from a position directly above the coin/mirror, the characters stamped onto the edge may be seen clearly. The mirrors are made from high grade aircraft aluminum or stainless steel and are polished flat to a 4 micron finish. They are cleaned with alcohol and a micro-fiber cloth. Each mirror is custom made for a certain size range of coins.Reverse edge mirrors are available for inspecting the inside areas of highly machined tubes. The variety of uses is limited only by one's imagination.

prototype stripping tool for 0.020 wire

Hand operated fixture for putting a precision slit in the end of a Toyota rubber part. Interchangeable nests allowed 4 different parts to be slit. Quality rate was approx 50% done by hand with a scissor. This fixture gave 100% quality and increased quantity 4X. Total of 800% increase in production of acceptable parts and freed up one production personnel allowing them to operate another molding machine. Payoff time for the device was one day. The client purchased 2 more fixtures, set up 2 more molding machines and ran the job at record rates and quality.
That's what we do for your bottom line!

Prototype of a coil varnish dyer

EXAMPLE OF A SINGLE PURPOSE MACHINE

SOME EXAMPLES OF THE COILS WE MANUFACTURE

120 nh

70 nh

10 uh

torodial inductor

500 nh